[etherlab-users] Bringing up the ethercat debug network interface

[Joe Brandt]

I tried both of the commands you listed below.

> Do you have an application running when trying this?
No. I've tried it with the cable disconnected, and the ec_master freshly
loaded. I get the same behavior.

One item of note: this is a 64bit system. Could this be a problem?

--jbrandt


Florian Pose wrote:
> Hi,
>
> On Tue, Nov 04, 2008 at 10:21:12AM -0500, Joe Brandt wrote:
>> What options do I need to provide ifconfig?
>
> 'ifconfig ecdbgm0 up' or 'ip link set dev ecdbgm0 up' should work fine.
> Do you have an application running when trying this?
>
> --
> Best regards,
> Florian Pose
>
> http://etherlab.org
> _______________________________________________
> etherlab-users mailing list
> etherlab-users at etherlab.org
> http://lists.etherlab.org/mailman/listinfo/etherlab-users
>


-- 
------------------------------------------------------------------------
    _/       _/   _/_/_/_/       _/           _/_/_/     National
   _/ _/    _/   _/      _/    _/ _/        _/     _/    Radio
  _/   _/  _/   _/_/_/_/      _/____/      _/     _/     Astronomy
 _/     _/_/   _/      _/    _/     _/    _/     _/      Observatory
_/       _/   _/        _/  _/       _/    _/_/_/        Green Bank, WV
Joe Brandt (N0NYO)                      jbrandt at nrao.edu (304)456-2210
------------------------------------------------------------------------