[etherlab-users] ethercat config

[Kim H. Madsen]

The blank line is a mail/paste problem, there are not on the target. 

I have this output:
~ # ethercat slaves
0  0:0  PREOP  +  EK1100 EtherCAT-Koppler (2A E-Bus)
1  0:1  PREOP  +  EL2004 4Ch. Dig. Output 24V, 0.5A
2  0:2  PREOP  +  EL1034 4Ch. Dig. Input 24V, potential-free, 10µs
3  0:3  PREOP  +  EL1004 4Ch. Dig. Input 24V, 3ms
4  0:4  PREOP  +  EL2004 4K. Dig. Ausgang 24V, 0.5A
5  0:5  PREOP  +  EL2004 4K. Dig. Ausgang 24V, 0.5A
~ # ethercat config
~ #

I get the output a bow then running "ethercat slave" and "ethercat config" commands. "ethercat slaves" command seems OK, but "ethercat config" a bit disappointing.

The master version is: IgH EtherCAT master devel 131f655c03d3+
Using generic device on a PowerPC.

Do I have a master/commandlinetool problem?


Best regards 
Kim Hedegaard Madsen 

-----Original Message-----
From: etherlab-users-bounces at etherlab.org [mailto:etherlab-users-bounces at etherlab.org] On Behalf Of Florian Pose
Sent: 14. april 2010 15:08
To: etherlab-users at etherlab.org
Subject: Re: [etherlab-users] ethercat config

On Wed, Apr 14, 2010 at 12:44:53PM +0200, Kim H. Madsen wrote:
> Shouldn't "ethercat config" always give an output with at least line per. Slave?

Yes.

> I have this output:
> 
> ~ # ethercat slaves
> 
> 0  0:0  PREOP  +  EK1100 EtherCAT-Koppler (2A E-Bus)

With the blank lines in between? Never seen this before. What revision
are you using? BTW, this is 'ethercat slave' output.

-- 
Best regards,
Florian Pose

http://etherlab.org
_______________________________________________
etherlab-users mailing list
etherlab-users at etherlab.org
http://lists.etherlab.org/mailman/listinfo/etherlab-users