[etherlab-users] WG: possible master problems

[Ian Norton]

Hi,

No, "p 0" still has no output for both commands!

regards
Ian

-----Original Message-----
From: Kim H. Madsen [mailto:khm at deif.com]
Sent: 09 March 2010 15:47
To: Ian Norton; Dipl.-Ing. (FH) Florian Pose
Cc: EtherLab Users List
Subject: RE: [etherlab-users] WG: possible master problems


It should be pdos -p 0 and not pdos -p0
Same for cstruct

Best regards 
Kim Hedegaard Madsen 
DEIF Wind Power Technology
Developer
Dir.:    +45 9614 8435

khm at deif.com

-- 
DEIF A/S
Frisenborgvej 33
DK-7800 Skive

Tel.: +45 9614 9614 
Fax:  +45 9614 9615

www.deifwindpower.com 

-----Original Message-----
From: etherlab-users-bounces at etherlab.org [mailto:etherlab-users-bounces at etherlab.org] On Behalf Of Ian Norton
Sent: 9. marts 2010 16:27
To: Dipl.-Ing. (FH) Florian Pose
Cc: EtherLab Users List
Subject: Re: [etherlab-users] WG: possible master problems

Hi,

I stopped and started the master, enabled debug 1. I switched my device on and off, then ran my program.

I did pdos -p0 and cstruct -p0 and there is no output!!!

Attached is the message file (copied to "pp").

I must be doing something stupid?

regards
Ian

-----Original Message-----
From: Dipl.-Ing. (FH) Florian Pose [mailto:fp at igh-essen.com]
Sent: 09 March 2010 14:58
To: Ian Norton
Cc: EtherLab Users List
Subject: Re: [etherlab-users] WG: possible master problems


Hello,

Am 09. März um 11:47 schrieb Ian Norton:
> I tried "0x1600", but it still kicks the drive into PREOP.

you can read the PDOs out of the slave with 'ethercat pdos -pX, or
better, 'ethercat cstruct -pX'.

> attached is the messages o/p

Please thry with the values from above, if it does not work, please
enable debugging before starting your application, like I wrote before,
because otherwise the logs are lacking the important debug messages.

-- 
Viele Grüße,
Florian Pose

------------------------------------------------------------------------
Dipl.-Ing. (FH) Florian Pose                 Amtsgericht Essen HRB 11500
Ingenieurgemeinschaft IgH                    USt-Id.-Nr.: DE 174 626 722
Ges. für Ingenieurleistungen mbH             Geschäftsführung:
Heinz-Bäcker-Str. 34                         Dr.-Ing. S. Rotthäuser
D-45356 Essen                                Dr.-Ing. T. Finke
Tel.: +49 201 / 360-14-13                    Dr.-Ing. W. Hagemeister
Fax.: +49 201 / 360-14-14                    Tel.: +49 201 / 360-14-0
fp at igh-essen.com                             http://www.igh-essen.com

GnuPG key: CCA047CC 2007-12-18 [expires: 2012-12-16]
Fingerprint: 0081 4005 FE9F 73FF 4BDA  A409 0011 4E20 CCA0 47CC
------------------------------------------------------------------------