[etherlab-users] Corrupt mailbox response

[takeshi ikeya]

Hello !!
Anyone knows the reason ?

I'm trying to use EtherLab's master.
When I connect one I/O slave (OMRON GX-MD1611), it goes all well.

I disconnect OMRON,  connect YASKAWA's Sigma5 servo driver, and make
EtherLab's master stop-and-start.
While master is starting, it scans the bus, and complains that it receives
'Corrupt mailbox response' , perhaps from YASKAWA (only one slave).
This happens before userspace application starts.

I can't drive YASKAWA yet.

What is wrong with YASKAWA ?

Below is syslog

EtherCAT: Master driver devel unknown
EtherCAT: 1 master waiting for devices.
ACPI: PCI interrupt for device 0000:03:06.0 disabled
ec_8139too EtherCAT-capable Fast Ethernet driver 0.9.28, master devel
unknown
ACPI: PCI Interrupt 0000:03:06.0[A] -> GSI 20 (level, low) -> IRQ 20
EtherCAT: Accepting device 00:07:40:1E:97:B3 for master 0.
ec0: RealTek RTL8139 at 0xce00, 00:07:40:1e:97:b3, IRQ 20
ec0: Identified 8139 chip type 'RTL-8139C'
EtherCAT 0: Link state changed to UP.
EtherCAT 0: Starting EtherCAT-IDLE thread.
EtherCAT 0: 1 slave(s) responding.
EtherCAT 0: Slave states: INIT.
EtherCAT 0: Scanning bus.
EtherCAT 0: Bus scanning completed in 8 ms.
EtherCAT 0: Slave states: PREOP.
EtherCAT ERROR 0-0: Corrupt mailbox response received!
EtherCAT DEBUG: 7E 00 01 00 00 63 00 80 04 00 00 00 01 10 05 00
EtherCAT DEBUG: 00 07 45 72 72 6F 72 20 52 65 67 69 73 74 65 72
EtherCAT DEBUG: 65 60 9A 60 B1 60 B2 60 B8 60 B9 60 BA 60 BC 60
EtherCAT DEBUG: C1 60 C2 60 E0 60 E1 60 F4 60 FC 60 FD 60 FE 60
EtherCAT DEBUG: FF 60 02 65 03 27 10 27 20 27 E0 27 3F 60 40 60
EtherCAT DEBUG: 41 60 5A 60 5B 60 5C 60 5D 60 5E 60 60 60 61 60
EtherCAT DEBUG: 62 60 63 60 64 60 65 60 66 60 67 60 68 60 6B 60
EtherCAT DEBUG: 6C 60 6D 60 6E 60 71 60 72 60 74 60 76 60 77 60


Thanks

takeshi.ikeya at gmail.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.etherlab.org/pipermail/etherlab-users/attachments/20101125/58152a20/attachment-0002.htm>