[etherlab-users] No output for 'ethercat config' in command-line-tool

[Marcel Rothgänger]

Hi,
 
I have a problem using the command-line-tool. The ethercat commands
‘slaves’, ‘pdos’, ‘cstruct’, etc. are working fine, but there is no output
for ‘config’:
 
//Here you can see, 'ethercat slaves' works fine:
 
user at Terminal:/dev$ /opt/etherlab/bin/ethercat slaves
0 0:0 PREOP + EK1100 EtherCAT-Koppler (2A E-Bus)
1 0:1 PREOP + EL9110 Einspeiseklemme mit LED (24V, Diagnose)
2 0:2 PREOP + EL1859 8K. Dig. Eingang 24V, 3ms, 8K. Dig. Ausgang 24V, 0.5A
3 0:3 PREOP + EL3111 1K.Ana. Eingang 0-20mA, Diff.
4 0:4 PREOP + EL3311 1K. Ana. Eingang Thermoelement (TC)
 
//No output for 'ethercat config':
 
user at Terminal:/dev$ /opt/etherlab/bin/ethercat config
user at Terminal:/dev$ 
 
//'ethercat config' is not an unknown function:
 
user at Terminal:/dev$ /opt/etherlab/bin/ethercat config --help
ethercat config [OPTIONS]
 
Show slave configurations.
 
Without the --verbose option, slave configurations are
output one-per-line. Example:
 
1001:0 0x0000003b/0x02010000 3 OP
| | | |
| | | \- Application-layer
| | | state of the attached
| | | slave, or '-', if no
| | | slave is attached.
| | \- Absolute decimal ring
| | position of the attached
| | slave, or '-' if none
| | attached.
| \- Expected vendor ID and product code (both
| hexadecimal).
\- Alias address and relative position (both decimal).
 
Can you tell me, what’s wrong?
 
Kind Regards,
Marcel
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.etherlab.org/pipermail/etherlab-users/attachments/20121201/e194d630/attachment-0002.htm>