[etherlab-users] control problem in servo motor

Sebastien Blanchet blanchet at iram.fr
Fri Dec 11 12:07:01 CET 2015


Hi,

Yes your program or your servo drive setup is probably wrong, but nobody can 
really help you because in spite of its length, your report is not efficient enough.

Indeed, writing an efficient bug report is not easy, so if I were you, I will 
first document myself with Google about "efficient bug report" during few hours, 
and then send an effective message to the mailing list so that someone can 
really give me clues to solve my problem.

Anyway the learning curve to setup a servo drive with ethercat is very steep,
so it is normal if the beginnings are hard-working.

good luck
-- 
Sebastien BLANCHET


On 12/11/2015 10:20 AM, Yin wrote:
>      Hi, I have encountered a problem and have no idea about the reason.
> I wrote an application program by using the etherlab ethercat library and
> tested the servo in profile velocity mode. I set the mode, target velocity
> and wrote controlword to switch to operation state.
>      But curiously, sometimes it run successfully and sometimes not. For the
> unsuccessful times, the error was almost over current or over speed, but the
> program was the same one. I tried to change target velocity to small, the error
> occurred as usual except changing to zero. The servo would be ok if I recovered
> it's configuration or just did nothing.
>      I really want to know the reason about this problem, is it my program have
> something wrong?
>



More information about the Etherlab-users mailing list