[etherlab-users] EL7211 - EEPROM No Access

[Henry Bausley]

Make sure you have --enable-sii-assign when you run ./configure to setup
the stack before compilation

On Fri, 2016-10-21 at 14:19 +0200, Philippe Leuba wrote:
> Hi,
> 
> I try to use a Beckhoff EL7211-0010 module but encounter the following error:
> 
> EtherCAT ERROR 0-3: Failed to set PREOP state, slave refused state change ( INIT + ERROR).
> EtherCAT ERROR 0-3: AL status message 0x0050: "EEPROM No Access ".
> 
> I have already tried to rewrite the sii with the file exported from TwinCAT, but without any changes.
> 
> Any ideas?
> 
> Philippe Leuba
> _______________________________________________
> etherlab-users mailing list
> etherlab-users at etherlab.org
> http://lists.etherlab.org/mailman/listinfo/etherlab-users





Outbound scan for Spam or Virus by Barracuda at Delta Tau