[etherlab-users] etherlab-users Digest, Vol 14, Issue 3

[Hobin Yoon]

I solved the problem by changing the uC to handle AL events, not DC
signals. Thank you!

Are you still look for support for the DC implementation? Could you
give me some starting point? I can be of your help.

Best regards,
Hobin Yoon

On Thu, Jul 10, 2008 at 9:18 PM, Florian Pose <fp at igh-essen.com> wrote:
> On Thu, Jul 10, 2008 at 03:44:33PM +0900, Hobin Yoon wrote:
>> I figured out that the uController is expecting interrupt signal and
>> it is started from DC and Sync/Latch PDI config register. I referenced
>> page I-72 of ET1100 data sheet ...
>
> DC is an optional feature of an EtherCAT slave. It surely can be
> disabled to run asynchronously. Is it possible, that the slave is still
> configured to use DC by TwinCAT? The IgH EtherCAT master does not reset
> the DC registers.
>
>> When do you plan to add DC to v1.4?
>
> I'm planning to implement this in the near future, but I'm still
> searching for people/companies to support the development, however.
>
> --
> Best regards,
> Florian Pose
>
> http://etherlab.org
> _______________________________________________
> etherlab-users mailing list
> etherlab-users at lists.etherlab.org
> http://lists.etherlab.org/mailman/listinfo/etherlab-users
>