[etherlab-users] Generic slave (unknown device) configuration

[Mladen Knezic]

Hi all,

Finally, I've got the EL9800 Eva Board working, everthing is fine, device is 
going to OP state, the LED is on (and the one that supposed to be on). Next, 
I will try to build some more complex model and to play around (to include 
analog in and some switches). :) Be free, to contact me for details if you 
are interested in this matter.

Xml generation using 'ethercat xml' command still doesn't work but I don't 
care (for now), because the Beckhoff's xml file doing the job very good.

And finally, some comments about this post:

http://lists.etherlab.org/pipermail/etherlab-users/2009/000540.html

Can someone explain how to set the input vector width in Generic Slave block 
(And what about the outputs? Are they really automatically set up correctly 
or they need some intervention too?)

Regards,

--
Mladen Knezic
Teaching Assistant
Faculty of Electrical Engineering
Banja Luka, Bosnia and Herzegovina
Web: www.etfbl.net
Phone: +387 65 804 205
Fax: +387 51 211 408