[etherlab-users] ETHERCAT Bus Coupler Question

[aj]

Very good thanks.
This will help a lot to keep the cost down.

regards,
ajith


______________________________________________________________________________________________
Ajith Boralugoda
President
CNC Lanka (PVT) Ltd
143/1 Meemanagoda Road
Kalalgoda
Pannipitiya
Sri Lanka
Tel/Fax : 0094112762624,009411493770
Hotline : 0094755002390
e-mail  : ab at cnclanka.com

www.cnclanka.com

CINCINNATI-SRILANKA (www.cincinnati-srilanka.com)
Sole Agents for:
MultiCam CNC Solutions from US ( www.multicam.com)
AlphaCam (www.alphacam.com) and ArtCam (www.delcam.com)  from UK.


On Wed, Jan 10, 2018 at 11:37 AM, Mike O'Connor <mike at oeg.com.au> wrote:

> On 10/01/2018 3:50 PM, aj wrote:
> > Hi! Mike,
> >
> > Please send me some details on the Leadshine.
> > My intention was to get going a solid component set without much
> > hassle.Later work on cutting cost by working on less expensive items
> > Like you suggest.
> > Please do share some details.
> > It does not hurt to take a look at it.
> > I suppose Getting LinuxCNC side working should not be a problem for me
> > Ilike to keep it Open Source Controller as these days people talk
> > about even promoting OpenSource
> > CHIPs(https://slashdot.us15.list-manage.com/track/click?u=
> aab6529d3675bd877963a652d&id=5148ab7ab9&e=b75feedc7f).
> > I like it I am a fan of power to people!!!
> >
> > Thanks for sharing your thoughts.
> >
> > regards,
> > ajith
> The information is at https://goo.gl/zpygJS
>
> The documentation fully describes there Ethercat configuration and with
> them having done the job correctly with no need for any external
> software to configure the drive. Ethercat all the way.
>
> Note I've not used there drivers as get but I plan to test them soon.
> (on the next few months)
>
> Cheers
> Mike
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.etherlab.org/pipermail/etherlab-users/attachments/20180110/f3871c83/attachment-0004.htm>