[etherlab-users] ETHERCAT Bus Coupler Question

[Mike O'Connor]

On 10/01/2018 3:50 PM, aj wrote:
> Hi! Mike,
>
> Please send me some details on the Leadshine.
> My intention was to get going a solid component set without much
> hassle.Later work on cutting cost by working on less expensive items
> Like you suggest.
> Please do share some details.
> It does not hurt to take a look at it.
> I suppose Getting LinuxCNC side working should not be a problem for me 
> Ilike to keep it Open Source Controller as these days people talk
> about even promoting OpenSource
> CHIPs(https://slashdot.us15.list-manage.com/track/click?u=aab6529d3675bd877963a652d&id=5148ab7ab9&e=b75feedc7f).
> I like it I am a fan of power to people!!!
>
> Thanks for sharing your thoughts.
>
> regards,
> ajith
The information is at https://goo.gl/zpygJS

The documentation fully describes there Ethercat configuration and with
them having done the job correctly with no need for any external
software to configure the drive. Ethercat all the way.

Note I've not used there drivers as get but I plan to test them soon.
(on the next few months)

Cheers
Mike