[etherlab-users] Master0 dead

[Fuchs Clemens]

Hi,
 
I installed the EtherCAT master stack 1.5, configerd it with proper MAC
address and it seems to have troubles starting.
I'm confused about different state messages -> please see outputs below:
 
------------------------------------------------------------------------
--------------------------------------------------------
> dmesg
EtherCAT: Master driver devel r1655
EtherCAT: 1 master waiting for devices.
ACPI: PCI interrupt for device 0000:06:04.0 disabled
ec_8139too EtherCAT-capable Fast Ethernet driver 0.9.28, master devel
r1655
ACPI: PCI Interrupt 0000:06:04.0[A] -> GSI 19 (level, low) -> IRQ 18
eth1: RealTek RTL8139 at 0xf8df4c00, 00:02:44:68:9e:33, IRQ 18
eth1:  Identified 8139 chip type 'RTL-8139C'
udev: renamed network interface eth1 to eth3
 

> /opt/etherlab/bin/ethercat master
Master0
  Phase: Waiting for device...
  Slaves: 0
  Device0: a2:ff:02:5d:a9:84 (waiting...)
    Tx count: 0
    Rx count: 0
  Device1: None.
 
> /etc/init.d/ethercat status
Checking for EtherCAT master devel 
Master0  dead
------------------------------------------------------------------------
--------------------------------------------------------
 
 
looking forward for any help!
 
thanks,
Clemens

Important Notice:
This electronic transmission (including any attachments) is intended solely for the use and information
of the addressee(s). It may contain confidential or legally privileged information. Any unauthorized use
or disclosure of this message is strictly prohibited.If you are not the intended recipient, please notify
the sender immediately and delete the message and its attachments.
The sender does not guarantee the integrity of this transmission and shall therefore never be liable if
the message is altered or falsified nor for any virus, interception or damage to your system.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.etherlab.org/pipermail/etherlab-users/attachments/20090211/93569e62/attachment-0003.htm>